国外标准列表

[国外标准] SAE AMS 4064F-2008 Aluminum Alloy.Clad Two Sides Sheet 1.25Mn- 0.12Cu (No. 12-0 Brazing Sheet) Annea

[国外标准] SAE AMS 4045J-2007 Aluminum Alloy Sheet and Plate 5.6Zn - 2.5Mg - 1.6Cu - 0.23Cr 7075 (-T6 Sheet, -T

[国外标准] SAE AMS 3909B-2008 Cloth,Aramid Intermediate Modulus

[国外标准] SAE AMS 3901C-1998 Organic Fiber (Para-Aramid), Yarn and Roving, High Modulus

[国外标准] SAE AMS 3650C-1991(2003) Rods, Sheets, and Molded Shapes, Polychlorotrifluoroethylene (PCTFE) Unplas

[国外标准] SAE AMS 3644G-2006 Polyimide, Molded Rod, Bar, and Tube, Plaque, and Formed Parts

[国外标准] SAE AMS 3605F-1993 Plastic Sheet, Post- Forming Cotton Fabric Reinforced Phenol- Formaldehyde

[国外标准] SAE AMS 3302G-1990 Silicone Rubber General Purpose 50 Durometer

[国外标准] SAE AMS 3278A-2008 Sealing and Coating Compound Polyurethane (PUR) Fuel Resistant High Tensile Stren

[国外标准] SAE AMS 3252J-2008 Synthetic Rubber and Cork Composition General Purpose Firm

[国外标准] SAE AMS 3250J-2008 Synthetic Rubber and Cork Composition General Purpose Soft

[国外标准] SAE AMS 2814F-2001 优质焊丝包的包装和标识

[国外标准] SAE AMS 2809-2002 Identification Titanium and Titanium Alloy Wrought Products

[国外标准] SAE AMS 2772E-2008 Heat Treatment of Aluminum Alloy Raw Materials

[国外标准] SAE AMS 2772C-2002 Heat Treatment of Aluminum Alloy Raw Materials

[国外标准] SAE AMS 2771C-2004 Heat Treatment of Aluminum Alloy Castings

[国外标准] SAE AMS 2759C-2000 Heat Treatment of Steel Parts General Requirements

[国外标准] SAE AMS 2759-9B-2003 Hydrogen Embrittlement Relief (Baking) of Steel Parts

[国外标准] SAE AMS 2759-7A-2006 Carburizing and Heat Treatment of Carburizing Grade Steel Parts

[国外标准] SAE AMS 2759-6A-2002 Gas Nitriding and Heat Treatment of Low-Alloy Steel Parts

[国外标准] SAE AMS 2759-5D-2004 Heat Treatment Martensitic Corrosion-Resistant Steel Parts

[国外标准] SAE AMS 2759-4B-2001 Heat Treatment Austenitic Corrosion-Resistant Steel Parts

[国外标准] SAE AMS 2759-3D-2005 Heat Treatment Precipitation-Hardening Corrosion-Resistant and Maraging Steel P

[国外标准] SAE AMS 2759-2C-2000 Heat Treatment of Low-Alloy Steel Parts Minimum Tensile Strength 220 ksi (1517

[国外标准] SAE AMS 2759-1C-2000 最低抗拉强度低于220 ksi (1517 MPa)低合金碳钢零件的热处理